 |
Chequer plate Wing Tops to fit Landrover
Defender 90 / 110 - TD / 200 / 300TDI / TD5
| 2mm (per pair) |
£28.50
|
|
| |
|
|
| 3mm (per pair) |
£36.50
|
|
| |
|
|
|
Our laser cut chequer plate wing top protectors
to fit Landrover 90/110/127/130 vehicles are the easiest and
most convenient way of protecting the wings of your vehicle.
All of our wing tops are pre-drilled for ease of fitment,
and lightly coutersunk to accept pop rivets*. They are also
double rolled to ensure correct alignment and sanded to prevent
personal injury. Rebel 4x4's five - bar tread plate wing top
protectors give added strength to your wings concealing ugly
dents and scratches whilst enhancing your vehicle's looks.
 |
Chequer plate Wing Tops to fit Landrover Series II/III
| 2mm (per pair) |
£28.50
|
|
| |
|
|
| 3mm (per pair) |
£36.50
|
|
| |
|
|
|
These full length laser cut ready to
fit aluminium wing top protectors for Series II/III Landrovers
are rolled and rounded at the front corners allowing them
to fit neatly on to the vehicles' wing. Drilled and and lightly
coutersunk to accept pop rivets*
 |
Chequer plate Wing Tops to fit Defender
Puma
|
 |
Chequer plate Bonnet Protector to fit
Landrover Defender 90 / 110 - TD / 200 / 300TDI / TD5
|
Rebel 4x4's standard chequer plate bonnet
protector for Landrover 90/110/127/130 models will improve
your vehicles appearance and safe guard the bonnet from being
damaged when using it to access the roof of your vehicle.
This protector is also pre-drilled and lightly coutersunk
to accept pop rivets*. It has a rolled front edge to give
it a snug fit in the recess of the bonnet.
It is also possible to remount your spare wheel carrier on
top of this protector.
 |
Full Bonnet Protector to fit Landrover Defender 90 /
110 - TD / 200 / 300TDI / TD5
| Full Bonnet Protector |
£99.00
|
|
| |
|
|
| |
|
|
| |
|
|
|
For maximum coverage of your bonnet we have
fabricated a Full Bonnet Protector which offers the utmost
protection as this is manufactured using heavy duty (3mm)
aluminium.
Again it is pre-drilled and lightly coutersunk to accept pop
rivets*. We recommend the use of expanding filler foam in
the recess of the bonnet to complete fitment.
 |
Chequer plate Bonnet Protector to fit
Landrover Defender Puma
|
|
Side Aluminium Chequer Sill & Rear Corner Protectors
| 2mm
Sill Protectors to fit Landrover Defender 90/Series
III SWB |
|
£21.50 |
|
|
|
|
| 2mm Sill Protectors
to fit Landrover 110 Van Type |
|
£27.50 |
|
|
|
|
| 2mm Sill Protectors
to fit Landrover 110 County |
|
£27.50 |
|
|
|
|
| 2mm Rear Corner Protectors
to fit Landrover Defender 90 2mm |
|
£10.50 |
|
|
|
|
| 2mm Rear Corner Protectors
to fit Landrover Series II/III SWB |
|
£9.00
|
|
| ADD
TO CART |
|
| 2mm Rear Corner Protectors
to fit Landrover 110 Van/County |
|
£17.50
|
|
| ADD
TO CART |
|
| 2mm Rear Crossmember
Cover to fit Landrover Defender 90/110 |
|
£21.00
|
|
| ADD
TO CART |
|
| 2mm Rear Crossmember
Cover to fit Landrover Series III |
|
£21.00
|
|
| ADD
TO CART |
|
| 3mm Sill Protectors
to fit Landrover Defender 90/Series III SWB |
|
£30.50
|
|
| ADD
TO CART |
|
| 3mm Sill Protectors
to fit Landrover 110 Van Type |
|
£36.50
|
|
| ADD
TO CART |
|
| 3mm Sill Protectors
to fit Landrover 110 County |
|
£36.50
|
|
| ADD
TO CART |
|
| 3mm Rear Corner Protectors
to fit Landrover Defender 90 |
|
£17.00
|
|
| ADD
TO CART |
|
| 3mm Rear Corner Protectors
to fit Landrover 110 Van/County |
|
£23.00
|
|
| ADD
TO CART |
|
| 3mm Mudflap Brackets
to fit Landrover Defender 90/110 |
|
£11.00
|
|
| ADD
TO CART |
|
|
Obtain the 50th anniversary look with our side aluminium chequer sill and rear corner protectors. Not only do these protection plates smarten the appearance of the Landrover, they also provide additional strength to your sills.
Our sill protectors are folded before they are cut so that you get the perfect look and finish once they are fitted to your vehicle.
|
|
90 Full Door Trim Set -
Deeper Type
|
 |
Bumper Tread Plates
| Natural Silver (per pair) |
£5.00 |
|
| |
|
|
| |
|
|
| |
|
|
|
 |
Clear Silicon Sealant
| Clear
Silicon Sealant |
£1.50 |
|
| |
|
|
|
|
|
As an optional extra we now offer
a clear sealant which can be used around the edges of
the chequer plate to create a seal between the chequer
plate panels and bodywork.
|
Back Body Liners and Rear Door Covers for Landrovers
Aluminium Back Body Liners** to fit Landrover Defender 90 / 110 / Series IIA & Series III are ideal for concealing any mishaps such as corrosion or electrolysis in your Landrovers’ rear body whilst protecting it from deterioration due to everyday wear.
To complete the interior of your Landrover we have an additional piece that fits against the rear bulkhead of your vehicle which is folded and then cut ready to slot into place.
You can cover as much or as little of your vehicle as you wish as we sell the panels seperately. For example if you wanted your back body to look like the one featured on the left it would cost you £42.50 for the floor plate, £42.50 for the two lower side plates, £39.00 for the bulkhead panel and £27.25 for the two upper side panels. The total cost to do this job would be just £151.25* - see price listing below.
*door cover sold seperately
To complete your back body, replace your decaying plastic covered hardboard door cover once and for all with one of our rear door covers made from 2mm aluminium. We make them for 90/110/130/Series II/III Landrovers as well as the Discovery.
It can be bought with or without a wiper motor cut-out and chequer plate panels to cover the wiper motor, door lock and stay bar are also available at an extra cost.
|
to fit Landrover 90 (Natural Silver)
Floor
panel to fit 90 (2.5mm)
|
|
£42.50
|
|
|
|
|
| Rear Lower Side Panels
to fit 90 |
|
£42.50
|
|
|
|
|
| Rear Upper Side Panels
to fit 90 |
|
£27.25
|
|
|
|
|
| Rear Bulkhead Panel
to fit 90 |
|
£39.00
|
|
|
|
|
| Door Cover without
wiper motor cut out (2mm) |
|
£32.50
|
|
| ADD
TO CART |
|
| Door Cover with wiper
motor cut out (2mm) |
|
£35.00
|
|
| ADD
TO CART |
|
| Chequer plate covers
for wiper motor, door lock and stay bar |
|
£24.95 |
|
| ADD
TO CART |
|
to fit Landrover 110 Van Type (Natural Silver)
| Floor
panel to fit 110 (3mm) |
|
£79.50
|
|
|
|
|
| Rear Lower Side Panels
to fit 110 |
|
£79.50
|
|
|
|
|
| Rear Upper Side Panels
to fit 110 |
|
£40.00
|
|
|
|
|
| Bulkhead Panel to fit
110 (2mm) |
|
£39.00
|
|
|
|
|
| Door Cover without
wiper motor cut out (2mm) |
|
£32.50
|
|
| ADD
TO CART |
|
| Chequer plate covers
for wiper motor, door lock and stay bar |
|
£24.95 |
|
| ADD
TO CART |
|
| Door Cover with wiper
motor cut out (2mm) |
|
£35.00
|
|
| ADD
TO CART |
|
to fit Landrover Ser III SWB (Natural Silver)
| Floor
panel to fit Ser III SWB (2mm) |
|
£42.50 |
|
|
|
|
| Rear Lower Side Panels
to fit Ser III SWB (2mm) |
|
£42.50 |
|
|
|
|
| Rear Upper Side Panels
to fit Ser III SWB (2mm) |
|
£27.25
|
|
|
|
|
| Bulkhead Panel to fit
Ser III SWB (2mm) |
|
£39.00
|
|
|
|
|
| Door Cover (2mm) |
|
£32.50
|
|
| ADD
TO CART |
|
to fit Landrover Ser III LWB (Natural Silver)
| Floor
panel to fit Ser III LWB (3mm) |
|
£79.50
|
|
|
|
|
| Rear Lower Side Panels
to fit Ser III LWB (2mm) |
|
£79.50
|
|
|
|
|
| Rear Upper Side Panels
to fit Ser III LWB (2mm) |
|
£40.00
|
|
|
|
|
| Bulkhead Panel to fit
Ser III LWB (2mm) |
|
£39.00
|
|
|
|
|
| Door Cover without
wiper motor cut out (2mm) |
|
£32.50
|
|
| ADD
TO CART |
|
to fit Landrover 110 County
| Please enquire for prices |
|
|
Discovery
- Click
here
for more info
*All prices shown are for products with
a Natural Silver finish.
**Please note some minor trimming may be required.
Pop rivets are not included
|
All photographs on this web site belong to Rebel 4 x 4
and may not be distributed or reproduced by any means,
or in any form, without Rebel 4 x 4 prior written permission.
ALL OF OUR NEW PRODUCTS ARE PATENTED |
